identifier	taxonID	type	CVterm	format	language	title	description	additionalInformationURL	UsageTerms	rights	Owner	contributor	creator	bibliographicCitation
593887E9424CFC0BFF64E3A99913FF67.text	593887E9424CFC0BFF64E3A99913FF67.taxon	http://purl.org/dc/dcmitype/Text	http://rs.tdwg.org/ontology/voc/SPMInfoItems#GeneralDescription	text/html	en	Shaanxispira Liu, Li, and Zhai 1978	<div><p>Genus Shaanxispira Liu, Li, and Zhai, 1978</p> <p>Type species. Shaanxispira chowi Liu, Li, and Zhai, 1978</p> <p>Emended diagnosis of the genus. A bovid of large size; horn-core long and straight, moderately divergent, homonymously twisted, slightly inclined, inserted behind the orbit, and with an antero-medial keel ascending from the antero-medial base of the horn-core to the top. Frontal higher than upper rim of orbit.</p></div> 	http://treatment.plazi.org/id/593887E9424CFC0BFF64E3A99913FF67	Public Domain	No known copyright restrictions apply. See Agosti, D., Egloff, W., 2009. Taxonomic information exchange and copyright: the Plazi approach. BMC Research Notes 2009, 2:53 for further explanation.		MagnoliaPress via Plazi	Shi, Qinqin;He, Wen;Chen, Shanqin	Shi, Qinqin, He, Wen, Chen, Shanqin (2014): A new species of Shaanxispira (Bovidae, Artiodactyla) from the upper Miocene of China. Zootaxa 3794 (4): 501-513, DOI: http://dx.doi.org/10.11646/zootaxa.3794.4.1
593887E9424FFC0FFF64E15E9EF0FB77.text	593887E9424FFC0FFF64E15E9EF0FB77.taxon	http://purl.org/dc/dcmitype/Text	http://rs.tdwg.org/ontology/voc/SPMInfoItems#GeneralDescription	text/html	en	Shaanxispira linxiaensis Shi & He & Chen 2014	<div><p>Shaanxispira linxiaensis nov. sp.</p> <p>(Figs. 3–4; Tables 1–3)</p> <p>Holotype. HMV 1922 (Figs. 3–4). An almost complete and undeformed skull.</p> <p>Etymology. The species name comes from the locality of the holotype, Linxia Basin.</p> <p>Geological distribution. Lower part of the upper Miocene, Liushu Formation, Linxia Basin, Gansu Province, China. The age of the associated fauna is equivalent to European MN9.</p> <p>Diagnosis. Horn-core with only one keel. Antero-medial keel large and wing-shaped, extending anteriorly intensively at the base and protruding above the frontal. Cross section of the horn base sickle-shaped. Horn-core inserted uprightly and caudally. Parietal slightly inclined in side view. Braincase short and broad. Paroccipital process strong. Depression medial to paroccipital process shallow, but without accessory articular surface. Supraorbital foramen small, facing mostly forwards, with distinct supraorbital groove extending to lachrymal. Preorbital fossa wide and shallow. Infra-orbital foramen above P3. Nasals domed. Muzzle low and narrow. Teeth mesodont, without strong ribs or styles. Premolar row much shortened. Basal pillars absent or weak.</p> <p>Description. The skull, HMV 1922, is nearly complete, with a well-preserved right horn-core. The tips of the horn-cores are broken, but skillfully restored with plaster. The tip of muzzle is missing. The right maxilla and left squamosal are slightly damaged. The tooth row is well preserved apart from the left P2 that is missing. The skull belongs to an adult specimen.</p> <p>The muzzle is relatively low, with the nasal aperture being about as broad as high. The nasal is narrow and domed, and slightly widens caudally. The caudal end of the nasal is pointed, extending behind the level of the anterior rim of the orbit (Fig. 3A, N). The naso-incisival notch is anterior to the level of P3. The infra-orbital foramen opens near the tooth row, at the level of P3 (Fig. 3B, Iof). The facial tuberosity is caudally positioned, close to the maxillo-jugal suture (Fig. 3B, FT). There is no facial crest. The facial part of the jugal is large and bilobed (Fig. 3B, Z). The lachrymal is small, quadrangular, long and low (Fig. 3B, L). The pre-orbital fossa is wide and shallow, without clear margins (Fig. 3A, PreoF). The maxillae close to the ethmoidal fissure are broken on both sides. However, the ethmoidal fissure is probably present because the nasal and lachrymal bones remain wide apart, and their margins are smooth, but size and shape of the ethmoidal fissure are uncertain (Fig. 3B, EF).</p> <p>The frontal is wide and flat in front of the horn-core, rising slightly above the orbit, and declining at the horncore. The bending of the frontal is weak (Fig. 3B, dashed lines). The mid-frontal suture is somewhat complex and elevated as a sagittal ridge before the horn bases, whereas between the horn-cores, the suture is flat, but more complex (Fig. 3A, F). The fronto-parietal suture points forwards in the centre, with the midpoint positioned between the horn-cores. The supra-orbital foramen is small, deeply sunken into the frontal, and facing mostly forwards, making the opening nearly round in anterior view, but tear-shaped in dorsal view (Fig. 3A, SoF). The internal opening of the supra-orbital foramen faces mostly downwards, and is more caudal than its external opening. The supra-orbital groove is long and distinct (Fig. 3B, SoG). There is no post-cornual fossa. The orbit is large with wide orbital rims; its dorsal border is lower than the frontal surface; its anterior border is posterior to the back of M3 (Fig. 3B). The lachrymal foramen is large, and is partitioned into two foramina by a thin bone layer (Fig. 3B, LF). The zygomatic arch is weak.</p> <p>The horn-core is straight, homonymously twisted, making a little more than one whorl, and diverging at an angle of about 35˚ (Fig. 3C). In lateral view, the horn-core is inserted far behind the orbit and is almost perpendicular to the dorsal border of the cranium, and only slightly inclined backwards (Fig. 3B, HC). The anteromedial keel is large and wide, protruding like a wing (Fig. 3A, K). The keel twists homonymously, following the twist of the horn-core. At its base, the keel occupies an antero-medial position on the horn-core, extending anteriorly to the level of the posterior rim of the orbit, and being strongly prominent above the frontal (Fig. 3B, K). As the keel ascends from the base to the tip, the size decreases gradually. In the basal part, the keel has a thickened margin (approximately 2 cm wide at the base, and becomes thinner upwards) with porous surface, whereas the surface of the horn-core is covered by many small longitudinal grooves. The cross section of the horn base is sickle-shaped because of the prominent keel. There is no posterior keel.</p> <p>The braincase is short and wide, with parallel lateral sides (Fig. 3C). The lateral part of the parietal is long, separating the frontal from the squamosal. The temporal lines are wide apart (Fig. 3C, TL). The occipital is low and broad. The angle between the parietal and occipital planes is about 120˚ (Fig. 3B). The nuchal crest is thick, with a coarse and large external occipital protuberance below (Fig. 3C, NC). The mastoid exposure is long and broad; its dorsal part faces caudally and the ventral part faces laterally. The mastoid exposure is separated from the parietal by the squamosal and the occipital.</p> <p>a Measurements taken from Zhang (2003); b Estimated measurement</p> <p>a Measurements taken from Zhang (2003)</p> <p>b The longest distance from antero-medial point to posterior-lateral point</p> <p>c The diameter perpendicular to the antero-posterior diameter</p> <p>The foramen magnum is large (Fig. 3C, FM). The occipital condyle is not as strong as in other “ovibovines” like Hezhengia or Plesiaddax; it is divided into dorsal and ventral articular surfaces by a clear ridge, and the dorsal articular surface forms a notable angle with the occipital surface above (Fig. 3B, OC). The depression between the condyle and paroccipital process is shallow and small, but no accessory articular surface is visible (Fig. 4A). The paroccipital processes are broken on both sides, with their bases considerably robust and converging anteriorly (Fig. 4A, PoP).</p> <p>The basioccipital is rectangular and thick. A deep and broad longitudinal groove runs along its midline (Fig. 4A, Bo). Both the posterior tuberosity and the pharyngeal tuberosity are well developed and of similar size (Fig. 4A, PhT, PostT). The basioccipital makes an angle with the palate of about 20˚. The auditory bulla is large and round. The posterior tip of the auditory bulla is laminar, positioned laterally to the paroccipital process. A triangular muscular process is visible anterior to the auditory bulla (Fig. 4A, AB). The hyoid fossa is deep and small, and hardly observable in ventral view (Fig. 3B, HF). The external auditory duct is small and short, pointing postero-laterally (Fig. 3B, EAD). The oval foramen is moderate in size, facing mainly laterally (Fig. 4A, FV). The pterygoid crest is robust (Fig. 4A, PtC). The ventral border of the pterygoid process of the sphenoid is thick. A small groove is observed along the spheno-pterygoid suture in ventral view (Fig. 4A, SPP, Pt). The palatine is long, and the anterior edge of the choanae is much more caudal than the tooth row (Fig 4A, Pl).</p> <p>The cheek teeth are mesodont. The premolar row is short, and the length ratio of premolar to molar row is 54% (Fig. 4B, Table 3). P2 is broken, but was certainly small. Its lingual border is straight. P3 is larger than P2, with a round lingual border. The width of P3 is similar to its length. The protocone is more distal than the paracone. The fossette of P3 is simple but deep. P4 is similar to P 3 in morphology but is a little larger. The protocone is more mesial, making P4 almost symmetrical. The fossette is long and narrow, with its anterior and posterior ends close to the border of the tooth. A spur is observed in the posterior part of the fossette, pointing forwards.</p> <p>M1 is almost square, being only slightly wider than long. The first lobe is shorter than the second lobe. The fossettes are U-shaped, and lack spurs. The lingual valley is narrow but deep, reaching almost 1/3 of the width of M1. The enamel island is thin and long. There is a tiny basal pillar on the posterior lobe of M1. M2 is much larger and longer than M1. The parastyle and mesostyle are moderately strong in M2, whereas the metastyle is not developed, and the buccal ribs are weak. The fossettes are simple, with the anterior and posterior ends close to the buccal wall. There are small folds along the border of the fossettes, but no distinct spur. The enamel island is also thin and long in M2. M3 is similar to M 2 in size and morphology, but is a little longer and narrower. The ribs and styles are even weaker in M3 than in M2, with only a moderately developed parastyle. There is no enamel island in M3, and the lingual valley penetrates deeply towards the buccal wall.</p></div> 	http://treatment.plazi.org/id/593887E9424FFC0FFF64E15E9EF0FB77	Public Domain	No known copyright restrictions apply. See Agosti, D., Egloff, W., 2009. Taxonomic information exchange and copyright: the Plazi approach. BMC Research Notes 2009, 2:53 for further explanation.		MagnoliaPress via Plazi	Shi, Qinqin;He, Wen;Chen, Shanqin	Shi, Qinqin, He, Wen, Chen, Shanqin (2014): A new species of Shaanxispira (Bovidae, Artiodactyla) from the upper Miocene of China. Zootaxa 3794 (4): 501-513, DOI: http://dx.doi.org/10.11646/zootaxa.3794.4.1
